Skip to main content

Masonry Anchor

Fastener used to attach OMG Termination Bar to concrete or masonry walls.  Fasteners have a zinc plated steel pin and are available in 1/4-in. and 3/16-in. Five lengths available from 7/8-in. to 2-in.

Find a Distributor Find an OMG Representative
Features & Benefits

Features & Benefits

  • Typical pullout values in cured concrete (3000 psi) are 400 lbs. for the 3/16-in. shank diameter, 800 lbs. for the 1/4-in. shank diameter zinc alloy anchors.
  • The GSA number for government projects is FFS-325, Group V, Type 2, Class 3 for zinc alloy anchors.
Product Use

Product Use

Pre-drill a 1/4-in. or 3/16-in. hole using a carbide tip SDS or straight shank drill bit. The diameter of the hole must match the shank diameter of the masonry anchor. The pre-drilled hole must be a minimum of 1/2-in. deeper than the anchor embedment. The OMG Masonry Anchor is then installed with a hammer.

Prior to job start, contact OMG to perform a pull out test to determine deck suitability and pullout values.

Minimum fastener embedment into the wall should be 5/8-in. for the 3/16-in. shank masonry anchor and 3/4-in. for the 1/4-in. shank masonry anchor.

Technical Data

Technical Data

Available in 1000 piece bulk cartons or 1000 piece cartons which contain ten 100 piece boxes.

Material: Zinc Alloy

Pin Material: Zinc Plated Steel

Packaging Information

Packaging Information

Bulk Cartons

Cat. No. Pin Diameter (in) Pin Length (in) Packaging Quantity Weight (lbs)
MA316 3/16 7/8 1000 10
MA001 1/4 1 1000 20
MA114 1/4 1 1/4 1000 22
MA112 1/4 1 1/2 1000 25
MA002 1/4 2 1000 31

100 Piece Boxes

Cat. No. Pin Diameter (in) Pin Length (in) Packaging Quantity Weight (lbs)
MA316X 3/16 7/8 1000 10
MA001X 1/4 1 1000 20
MA114X 1/4 1 1/4 1000 22
MA112X 1/4 1 1/2 1000 25